Yazaki Part No. is set based on the rules below.
Yazaki Part No. consists of 10 digits. [(1)(2)(3)(4)-(5)(6)(7)(8)-(9)(10)]
[(1) : Product or component]
[(2) : Single or Assembly]
* There are some products which can't be found if you search with Part No. 73- .
Please change Part No. to 72- or 71- and search again.
[(3)(4) : Classified Parts]
[(5)(6)(7)(8) : Consecutive number]
[(9)(10) : Identify classification of components
* Condition of Part No is subject to change without notice
Documents can be downloaded from website are as shown below.
Please read the following terms and conditions carefully before using download service.
To search for products, you can use the following methods;
A non-conductive part which is designed to position, protect and insulate terminals from contact wih each other or external parts.
A housing designed to contain male terminals is referred to as a housing, while that designed to contain female terminals is referred to as a female housing.
A mating terminal to be connected electrically with a female terminal.
There are tab/blade tye, pin type ( round head ) and pin type ( square head ) for the PCB ( Printed Circuit Board ).
A terminal to be connected electrically with a male terminal. This terminal has a spring device inside which generates the contact load.
A device used to fill an unoccupied cavity of a sealed connector housing, type connector grommet.
A terminal provided with a locking arms to lock it in the housing.
A plastic arm designed in the housing cavity to hold the terminal in position.
The part of a terminal where the conductor ( wire without insulation ) is crimped. There are both "closed grip-type", and "open grip-type" terminals.
The part of a terminal where the insulation of the wire is crimped.
A device provided on a housing to assure that physical/electrical positive contact is maintained detween the mated parts.( Terminal-to-housing, housing-to-housing )
A part used in conjunction with a housing to assure the terminals are in proper position for mating.
A system to lock terminals in a housing cavity, insert terminals completely, or increase terminal retension force by use of a secondary locking system ( spacer, pear holder, etc ). This system is used in addition to terminal lances or plastic arms in the housing cavity.
A connector containing terminals of different sizes and/or configurations.
A connector soldered to the electrical conductive pathways of the printed circuit board.
A connector integrated with an electrical component such as a regulator, wiper motor,sensors, etc. ( usually, male connectors ).
A connection system used to combine /joint different branches of a circuit. Typically used instead of a "wire splice".
A connector for the PCB ( Printed Circuit Board ) whose male and female housings are mounted vertically to the printed circuit board.
A connector for PCB ( Printed Circuit Board ) whose male and female housings are mounted horizontally to the Printed Circuit Board.
Return to support top page